|
| • | AV control center |
| • | KRF-V8090D-S |
| • | Surround power output: 130W x 7 (1-ch driven, 6 ohms, 1kHz, 10% THD) |
| • | Surround power output: 120W x 7 (1-ch driven, 6 ohms, 1kHz, 0.7% THD) |
| • | Surround power output: 100W x 7 (1-ch driven, 6 ohms, 20Hz-20KHz, Front/Centre 0.09% THD, Surround/Surround back 0.7% THD) |
| • | Dolby Digital SURROUND EX, DTS 96/24, DTS-ES, DTS, Dolby Digital, Dolby Pro Logic IIx |
| • | 7-ch power amplifier built-in with capability to drive Surround Back Left/Right speakers |
| • | 5 DSP listening modes |
| • | Kenwood Room Acoustic Calibration |
| • | Active EQ with Cinema, Music and Game modes |
| • | 96kHz/24-bit audio reproduction capability |
| • | Midnight mode (Dynamic compression system in Dolby Digital mode and DTS mode) |
| • | Loudness control |
| • | Bass boost |
| • | Full Auto Digital/Analog Source Input Selector |
| • | Set up memory for each channel/Input sensitivity control (Input level adjust by 3 steps) |
| • | Digital REC mode (Auto/Manual) |
| • | 32-Bit floating-point SHARCR Processor by Analog Devices |
| • | Dolby Virtual Speaker and Dolby Headphone |
| • | Linear TRAIT discrete power amplifier stage |
| • | Kenwood original chemical condenser for high quality sound |
| • | Advanced Ground Line |
| • | Speakers A/B & A+B function |
| • | Independent speaker level control adjustment |
|
|
|
| • | Front Speakers |
| • | LS-9070ES-M |
| • | 3-way 6-speaker Resonance Acoustic Tube System |
| • | Woofer: 80mm cone type x 4 |
| • | Midrange: 80mm cone type x 1 |
| • | Tweeter: 19mm dome type x 1 |
| • | 8 Ohms impedence |
| • | Maximum input level: 130W |
| • | Sensitivity: 83dB /W at 1m |
| • | Frequency Response: 30Hz-40kHz |
| • | Srew type terminals with banana-plug support |
|
|
|
| • | CS-7070ES-M |
| • | 2-way 3-speaker Acoustic Air Suspension System |
| • | Woofer: 80mm cone type x 2 |
| • | Tweeter: 19mm dome type x 1 |
| • | 8 Ohms impedence |
| • | Maximum input level: 130W |
| • | Sensitivity: 79dB /W at 1m |
| • | Frequency Response: 60Hz-100kHz |
| • | Srew type terminals with banana-plug support |
|
|
|
| • | LS-5070ES-M |
| • | 2-way 2-speaker Bass-Reflex System |
| • | Woofer: 80mm cone type x 1 |
| • | Tweeter: 19mm dome type x 1 |
| • | 8 Ohms impedence |
| • | Maximum input level: 70W |
| • | Sensitivity: 77dB/W at 1m |
| • | Frequency Response: 60Hz-100kHz |
| • | Srew type terminals with banana-plug support |
| • | Independent speaker level control adjustment |
|
|
|
| • | SW-508ES-M |
| • | Bass-Reflex, floor standing type enclosure |
| • | Speaker units: 160mm cone type x 2 |
| • | 8 Ohms impedence |
| • | Total Dynamic Power: 150W, 75W+75W |
| • | Frequency Response: 30Hz-8kHz |
| • | Crossover frequency range: 60Hz-200Hz |
| • | 1 RCA input |
| • | Speaker level inputs |
| • | Auto off/on |
| • | Volume control on front panel |
| • | Crossover control on front panel |